Benefits of using RE-NEW SURFACE SYSTEMS

Re-New Surface: is a crystal that is mixed with water at a specific ratio. The liquid is then used in cement and washed sand to acquire a specific slump. Once the mixture has been brought to the desired slump, it is placed on the damaged concrete surface, and finished as desired.
Re-New Surface: overlays may be placed on bridge decks, sidewalks, curbs, and concrete road surfaces. They are also used in multi-level structures since the overlays only need to be thick enough to replace the deteriorated surface, therefore not adding additional weight to the existing structure.
Re-New Surface: overlays are slightly lighter in colour than the regular concrete due to the lighter coloured sand being used in mixture.
Re-New Surface: overlays are freeze-thaw and salt-resistant, and are also more flexible, making these overlays less apt to cracking.
Re-New Surface: overlays have up to 6700 PSI in seven days at a mix of 3 to 1 (sand-to-cement ratio) by weight, in a slurry mix (test results).
Re-New Surface: is available in 16 colours. Tests (CSA A23, 2-9C) show a compressive strength of 2600 PSI at seven days.
Re-New Surface Colour Sealer: protects the colour overlay against UV rays as the colour pigments are organic and will fade without the protection. It makes the overlay water-repellent, reduces straining, washes easily, is non-slip, and is applied with a rough surface paint roller. It covers 200 to 250 sq.ft. per gallon and should be resealed every five to seven years, depending on surface wear.
Re-New Surface Industrial Sealer: is an elastomeric liquid styrene eaylate that will protect the concrete surface against oil, gasoline, anti-freeze and most chemicals, and it will also prevent concrete dusting. It can be applied by roller or trowel. This sealer bridges all cracks that do not affect structural strength. This sealer remains flexible on the surface, allowing it to bridge existing and new cracks after application.
If Re-New Surface overlays have a downside, it is that it must be applied in a specific way. If the instructions are not followed exactly, the overlay could fail. Failures have been approximately 10 per cent over the years, and these were at working joints where the overlay was not cut, marked or placed exactly over the existing joint.